HGV split break: your 45 minutes must be 15 then 30 — not the other way round
My driver took 30 minutes at Knutsford then 15 more. Analysis came back clean. DVSA found an infringement. The split break order isn't optional.

My driver stopped at Knutsford services on a Thursday in November. Thirty minutes — proper break, out of the cab, food, coffee. Then drove on. An hour and a bit later, on the A556, he took fifteen minutes before his next drop. Total break: forty-five minutes. Tachomaster analysis came back clean. DVSA pulled him three weeks later at Hilton Park and found an infringement.
The split break rule has a mandatory order. Thirty then fifteen doesn't satisfy it. The only valid split is fifteen minutes first, then thirty. Get it backwards and the forty-five minutes you logged still counts as an infringement.
Article 7 of EC Regulation 561/2006
After four and a half hours of driving, a driver must take an uninterrupted break of not less than forty-five minutes. That's the rule. Simple enough.
But Article 7 also allows a split. And this is where operators go wrong.
The split is allowed — but only in one specific order. The first portion must be at least fifteen minutes. The second must be at least thirty minutes. The legislation text is explicit: "a break of at least 15 minutes followed by a break of at least 30 minutes." That's it. No other arrangement satisfies Article 7.
A thirty-minute break followed by a fifteen-minute break doesn't comply — regardless of whether the total equals forty-five minutes.
Why the order matters
The four-and-a-half-hour driving accumulation clock runs continuously from when the driver starts driving. It doesn't reset until the full break obligation is discharged. And the obligation isn't discharged until the driver completes the break in the correct order.
Taking a thirty-minute break at hour three doesn't pause the clock in any useful way. The driver still needs thirty more minutes before the obligation is met. But a further thirty-minute second portion after a thirty-minute first portion isn't the rule — the second portion must be thirty minutes minimum, and you've already "spent" your thirty. A fifteen-minute second portion falls short. Infringement recorded.
So the driver ends up without a valid break and with an Article 7 infringement despite two breaks totalling forty-five minutes.
What analysis software misses
I've tested this with four different tachograph analysis packages. Feed in a 30+15 split and see what happens.
Two of the four flagged no infringement at all. One flagged a "break event query" that buried the issue in seventeen other low-level flags. One correctly identified the infringement under Article 7.
If you're relying on automated analysis to catch this — and most operators are — you might have a compliance gap you don't know about yet.
Ask your analysis provider directly: does your system check the order of split breaks, or just the total duration? If they're not sure, that tells you something. Run a test file with a deliberate 30+15 split and see what it reports.
Drivers doing long A-road runs between drops naturally tend toward a long break at services, then a shorter one later. Which is exactly the wrong way round.
Worked example: correct vs wrong
Driver starts at 06:00.
Option A — correct split. At 08:30 (two and a half hours in), takes a fifteen-minute break at services. Back driving at 08:45. At 10:30 — four and a half hours cumulative from 06:00 — takes the thirty-minute break. Clock resets at 11:00. Can drive a fresh four-and-a-half hours from there.
Option B — wrong order. At 09:00 (three hours in), takes a thirty-minute break at services. Back driving at 09:30. At 10:30 — four and a half hours cumulative — must stop. Takes fifteen minutes at 11:00 assuming the break is satisfied. It isn't. Article 7 infringement.
The trap is that Option B feels reasonable. The driver got a proper meal break. They weren't pushing through. But the sequence breaks the rule.
How the 4.5-hour clock resets
The driving clock only resets when the full break obligation is satisfied — both portions, in the correct order, completed before the cumulative driving hits four and a half hours.
After a fifteen-minute first portion, the clock is still running. The break isn't complete. Only the end of the thirty-minute second portion resets it.
A driver who takes fifteen minutes at hour two, drives another two and a half hours, then takes thirty minutes — that's compliant. Fifteen first, thirty second, completed before the four-and-a-half-hour mark. Good.
A driver who takes thirty minutes at hour three, drives on for another ninety minutes hitting the limit, then takes fifteen to finish — that's an infringement. Wrong order, and the second portion is fifteen minutes, which is below the minimum.
What counts as driving time
Not all time at the wheel contributes to the four-and-a-half-hour accumulation in the same way. The tachograph records driving time when the vehicle is moving. Short stops in traffic don't reset the clock — but very brief stationary periods in heavy urban congestion may not accrue significantly either.
What doesn't count as a break: sitting stationary at a level crossing, waiting at traffic lights, queuing at a fuel pump. A break must be a deliberate non-driving period, not incidental waiting. If the card is in driving mode and the vehicle is stationary for a few seconds at lights, that time still accrues.
Drivers doing urban work — multiple drops, lots of traffic — can hit four and a half hours of driving time faster than they expect. If they're not watching the tachograph display, they may not realise how close they are.
Domestic rules don't help here
If a vehicle operates under GB domestic rules — the Transport Act 1968, not EC 561 — the break structure is different. Domestic hours have their own requirements, and the specific 15-then-30 split doesn't apply in the same way.
But most HGVs over 3.5 tonnes on commercial journeys run under EC 561, not domestic rules. The exemptions are narrow: specific vehicle types, short-radius haulage under defined conditions, a handful of others. If you're running a standard goods vehicle fleet and assuming domestic rules apply, check the actual exemption criteria before relying on that.
What DVSA look for at a roadside stop
At a fixed-site check — Knutsford, Lymm, Hilton Park, Cinderford — the examiner downloads the driver card and runs an analysis. DVSA's own systems are generally more rigorous than commercial packages on break order. A 30+15 split will typically be flagged.
The examiner has discretion on how to proceed. A fixed penalty for the driver, a report to the operator, or both. A break-order infringement on its own is typically a minor or serious categorisation depending on circumstances — one event might result in a fixed penalty and an OCRS entry. A pattern across multiple downloads shifts this toward a targeted investigation.
Operator liability and briefings
Section 96 of the Transport Act 1968 makes causing or permitting a drivers' hours breach an offence. Isolated break-order infringements usually land on the driver as a fixed penalty. But if your scheduling makes a correct split break impossible — too tight between drops, no suitable stop — the operator comes into frame.
Document your driver briefings. Date them. Have drivers sign that they understood. If your routes are tight, fix the route, not the record. This is the documentation that matters at a public inquiry.
The briefing I give new starters: the first stop is the short one. Fifteen minutes. Quick fuel, comfort break, done. The second stop is the sit-down. Thirty minutes minimum, every time. You always do the short one first. It takes two minutes to explain and I've had zero Article 7 infringements since I made it part of induction.
Check your analysis software this week
Three actions. Upload a test file with a deliberate 30+15 split to your analysis package and see what it flags. Brief every driver specifically on the order — not just the total time. And if any of your regular runs leave insufficient time for a properly sequenced split break, that's a route planning problem to fix now rather than an infringement to explain later.
What analysis software should flag — but often doesn't
The split break is one of the harder infringement types for automated systems to catch correctly. Duration checks are easy. Order checks require the software to read the sequence of the two break events, compare the first and second durations, and flag when the thirty appears before the fifteen.
I've spoken to two tachograph analysis providers about this. One confirmed their system checks order explicitly. The other said it applies "standard drivers' hours rules" — which turned out to mean duration only. Neither of them flagged it clearly in their marketing materials.
So test yours. Upload a deliberately constructed test file with a thirty-then-fifteen split and see what comes back. If the system passes it clean, you have a gap. Your download review process needs to compensate for it manually until the provider can confirm a fix.
The other thing to check: whether your system flags the first portion duration correctly. Some systems look for a minimum fifteen-minute first break. Others just look for two break events with a combined forty-five minutes. If the first break in the split is ten minutes and the second is thirty-five, that's also an infringement — the first portion must be at least fifteen. Does your software catch that?
Route planning and the practical problem
The split break rule creates a genuine planning challenge on tight runs. A driver doing a seven-hour single-person delivery run with drops every ninety minutes doesn't always have an obvious window for a fifteen-minute first break followed later by thirty minutes at a suitable location.
If your route doesn't naturally accommodate this — if the timing between drops is so tight that drivers are taking whatever break they can whenever they can — that's a schedule problem. Not a driver problem. And DVSA look at it that way too. At a public inquiry following repeat infringements, a transport manager who says "the drivers just weren't following the rules" doesn't get much sympathy if the route plan made compliance structurally difficult.
Review routes where your download review consistently shows break order issues. It might be a driver briefing problem. It might be a scheduling problem. Either way, you need to know which before you can fix it.
The OCRS and public inquiry picture
A single break-order infringement will add an OCRS point. It's not catastrophic on its own. In the context of an otherwise clean record — good PMI history, consistent download record, no prohibitions — one Article 7 infringement gets absorbed.
The picture changes when infringements accumulate. Six months of data showing repeated 30+15 splits across multiple drivers means two things: a pattern of non-compliance, and evidence that your monitoring process isn't catching it. Both of those are what the Traffic Commissioner focuses on at a public inquiry. Not the individual infringements, but what the pattern says about your systems.
If your OCRS shifts into red band — which can happen with consistent infringement patterns — DVSA increases targeted roadside check frequency. More checks means more data. More data, if your drivers are still doing 30+15 splits, means more OCRS entries. It compounds.
The way to avoid this is simple but requires consistent effort: brief drivers specifically on the order, test your analysis software on split breaks, and review every split break in your monthly download review rather than relying on automated flags alone.
What to do if a driver gets a fixed penalty
If a driver receives a fixed penalty notice for a break infringement at a roadside check, the operator should be notified by DVSA within a few weeks. The notification isn't always prompt — sometimes it arrives a month after the roadside stop.
When it arrives: debrief the driver. Find out what happened, why the break was in the wrong order, whether it was a time pressure issue or a misunderstanding of the rule. Document the debrief. Add the infringement to your monthly analysis review and flag whether the route or schedule contributed.
Then check the rest of your fleet's data for the same pattern. If one driver has been doing 30+15 splits, there's a reasonable chance others have been too. A systematic check in the month following any fixed penalty is good practice and demonstrates you take infringement notification seriously.