Back to blog
Driver Management13 June 20266 min read

New driver on the fleet: the 13-week check routine I run before taking them off supervised shifts

Clean licence at interview means nothing about what a driver does on the A1 alone. Here's the 13-week check routine I run for every new starter.

New driver on the fleet: the 13-week check routine I run before taking them off supervised shifts

A clean licence tells you almost nothing

I've been surprised by that more times than I'd like to admit. A driver presents with a full Category C+E licence, no endorsements, five years' experience at a previous employer. References check out. Interview goes well. They seem organised.

And then they're on your fleet, alone, and the tachograph analysis from their first three weeks shows four missed breaks, two reduced daily rests, and a manual entry that doesn't match the ferry crossing time they recorded.

The licence doesn't tell you how they drive. Previous employers don't always tell you everything. And habits — bad ones especially — are invisible until you're watching them in data.

The first thirteen weeks are the most important of any driver's time on your fleet. Here's the routine I run.

Weeks 1-2: the accompanied shift

Every new driver on my fleet does at least one supervised shift in the first two weeks. Not a full driving assessment — they've passed their tests, they don't need teaching. What I'm looking for is the pre-trip routine, the walkaround quality, and how they talk about the vehicle.

A driver who's confident and methodical doing the daily check was usually trained properly by their previous employer. A driver who rushes through it, doesn't check the fifth-wheel coupling tension, misses the nearside rear tyres — that tells me something different.

I also use week one to establish expectations directly. Not a lecture. A conversation. What the tachograph compliance requirements are. When breaks must be taken and how they're to be recorded. What happens if there's a vehicle defect. And — importantly — what the consequence is of a tachograph infringement. I want the driver to know I look at the data every week, personally. Not to frighten them. To be clear that this is how the fleet runs.

Weeks 3-6: weekly tachograph review

For the first six weeks after the supervised shift, I pull every new driver's tachograph data weekly rather than the normal fortnightly cycle. Takes me about 20 minutes per driver per week. It's the highest-value twenty minutes I spend.

I'm looking for four things: break compliance (45 minutes after no more than 4.5 hours continuous driving), daily rest (minimum 11 continuous hours, or the split rest pattern correctly structured at 3 + 9 hours), driving time (under 9 hours daily, under 56 hours weekly), and manual entry quality.

Manual entries are the tell. A driver who makes manual entries correctly — right format, right codes, right times — has been trained to DVSA standard. A driver who skips manual entries for ferry crossings, or codes other work as rest, or forgets to record loading time — that's something to address now, not when DVSA finds it at a roadside check three months later.

Any infringement in weeks 3-6 gets a documented conversation. Not a written warning yet. A face-to-face discussion where we look at the data together and they explain what happened. Sometimes it's genuinely a one-off. Sometimes it's a pattern that continues into week 7, and then the conversation changes.

Weeks 7-9: the walkaround audit

By week seven, the driver should know the walkaround routine. I do an unannounced audit at this point — I'm in the yard when they arrive, watching but not intervening.

Specifically, I check: do they check tyre pressures or just kick the tyres? Do they check both sides of the vehicle, or just the driver's side? Do they record the same starting odometer they used in the digital walkaround? Do they check load security before setting off?

About a third of drivers I've taken on in the last five years have failed at least one of these points in the week-7 audit. Not badly. But enough that a pre-departure conversation was needed.

On a recent hire, the driver was checking the nearside tyres from the driver's side by walking around the rear. He couldn't see the nearside rear inner tyre of the trailer from that position. He'd been doing it that way for three years at his previous job and nobody had flagged it. Five minutes to fix. But if I hadn't looked, it would have continued indefinitely.

Weeks 10-12: documentation check

Three weeks before coming off the close-monitoring schedule, I run a documentation audit. Driving licence validity and category confirmation — I use the DVLA's online check service, which gives a live view rather than a copy of their card. DQC expiry date. Driver card expiry (cards last five years). ADR certificate if applicable.

Driver CPC cards expire every five years and require 35 hours of periodic training to renew. A driver who joined you with 18 months left on their DQC is in a different position to one with four years. Know which drivers need training investment in the next 12 months. You should be planning this, not finding out at the roadside.

I also check the DVLA licence online for any endorsements that have appeared since interview. Rare, but it happens. A SP30 picked up in month two needs to be notified to your insurer. A disqualification needs to be notified immediately and the driver taken off the road pending assessment.

Week 13: the sign-off

End of week 13, we have a 20-minute review. I bring the tachograph data summary for weeks 1-13. They bring their defect report log from the period.

I'm looking for a compliance rate above 95% on breaks, rest, and driving time. Any weeks below that, we discuss. And I'm looking for the driver to show they understand the rules — not just that they've been following them. A driver who can explain why reduced rest can only be taken three times between weekly rests is a driver who'll manage their hours properly when things go wrong on the road. That understanding is what I want to see.

If week 13 passes, the driver moves to normal monitoring frequency. If there are ongoing concerns, I extend the close monitoring by four weeks and set specific targets before sign-off.

The documentation I keep

Every stage of this routine generates a record. The accompanied shift assessment. The weekly tachograph analysis notes. The week-7 walkaround audit result. The week-10 documentation check. The week-13 sign-off conversation.

All of it goes in the driver file. Because if that driver is ever involved in an incident, and there's a question about what supervision I provided during their onboarding, I want the answer in writing. Not reconstruction from memory. Evidence.

A TC reviewing your compliance systems after an incident will ask what your new driver induction process looks like. "We give them a week with a senior driver and then check in monthly" is not a compelling answer. A dated set of records showing structured assessment over 13 weeks, with documented conversations for any issues found and resolved, is a very different kind of answer.

What the routine doesn't replace

Thirteen weeks of close monitoring doesn't replace a genuine driver assessment programme. If you're regularly taking on inexperienced drivers or drivers returning after a period off the road, a formal assessment by a qualified driver trainer — not just observation from me — is worth the investment.

I can spot whether someone is following the rules. I can't always diagnose why they're not. Novice error patterns are different from ingrained habit errors, and recognising the difference matters for how you address them. When I'm not sure, I bring in a trainer. Not often. But it's happened, and it's been worth it.

Driver ManagementprobationtachographCompliancewalkaroundDVSAnew-driver

Run a fleet that has to keep DVSA happy?

FleetPad replaces walkaround paperwork, defect logs, and PMI records with one system the transport manager actually reads.